Ultra motor A2B Hybrid Manuale di Servizio Pagina 42

  • Scaricare
  • Aggiungi ai miei manuali
  • Stampa
  • Pagina
    / 48
  • Indice
  • SEGNALIBRI
  • Valutato. / 5. Basato su recensioni clienti
Vedere la pagina 41
3. Remove the switch module (A, Figure 3)
and the wiring (B) from the compartment.
4. Disconnect the main battery connector
(B, Figure 1) and the charger port connec-
tor (D).
5. Move the switch module (E, Figure 1)
and wiring out of the way. If this requires
disconnecting other connectors, label the
connector halves.
6. Insert a lever through a strap in the bat-
tery (A, Figure 4).
7. Use the lever to carefully pry the battery
down the frame member, until the lever
can be inserted through both straps.
8. Pull the lever until the battery emerges
enough so an assistant can help, and
remove the battery from the frame down-
tube.
Installation
1. Carefully slide the replacement battery
into the frame until the battery bottoms in
place.
2. Connect the main battery connector (B,
Figure 4) and the charger port connector
(C) to their mates from the switch module.
The 3-pin connector (D) is not used in the
A2B Metro.
BATTERY CAP
Removal
1. Remove the right crank arm as described
in Chapter Five.
2. Remove the battery cap screws (A,
Figure 2) from each side, and remove the
cap (B) from the frame downtube.
3. Note how the switch module (A, Figure
3) and wiring (B) fit within the battery com-
partment.
4. Install the battery cap by reversing the
removal procedures.
a. Position the switch module as noted
during removal.
b. Tighten the battery cap screws (A,
Figure 2) securely. Do not overtighten the
screws
BATTERY
WARNING
Do not attempt to service this battery. It
has no serviceable components in it. If the
battery fails or is damaged, it must be
replaced.
WARNING
Do not use this battery in any other vehicle
or appliance. Use of this battery with any
other product will void the warranty and
may create a hazardous condition that
could cause a fire resulting in property
damage, severe injury, or death.
Removal
1. Remove the right crank arm as described
in Chapter Five.
2. Remove the battery cap as described in
this chapter.
Chapter Seven
7-2
FIG. 2
A
B
A
FIG. 3
A
B
FIG. 4
B
A
C
D
Vedere la pagina 41
1 2 ... 37 38 39 40 41 42 43 44 45 46 47 48

Commenti su questo manuale

Nessun commento